AKCP intelligent sensors
This sensor is designed for protecting against forced entry by hammer, saw, crowbar etc., through walls, ceilings, windows, safes, cabinets, etc., It will initiate an alarm when a vibration from a non-desirable force strikes the protected surface. A built-in tamper switch is independent from the circuit of the vibration detector for your convenience.
Vibration contacts are adjustable by turning an adjustment screw to respond to any surface - glass, wood, steel, plasterboard, or brick. Pure silver contact points ensure years of fail-free operation. Dust tight ABS case is small and inconspicuous and can be easily installed with two-sided adhesive tape.
Connection Flexibility
The vibrationGlassBreak sensor can be connected to the sensorProbe and securityProbe units via the RJ-45 dry contact sensors.
Or it can be directly connected to the dry contact inputs on the sensorProbe8-X20, sensorProbe8-X60, securityProbeX-20 and secuirtyProbe-X60 units allowing security protection for many windows using only a single base unit.
Vibration detection of glass breakage sensor
The AKCP Sensor glass is equipped with a vibration detector, which can be adjusted by means of a screw. So you can adjust the sensitivity of this sensor individually.
An integrated sabotage protection alerts you when the vibration detector opens the Gebhäuse the sensor glass break.
In the WebGUI sensorProbe or securityProbe monitoring devices, the sensor glass breakage can be easily configured with integrated Seismic detectors (Figure shows sensorProbe2 Web interface). Here you can see the online demo of sensorProbe2.
See here the sensorProbe8-X20 with 20 potential free contacts. You can connect the glass break sensors with seismic detectors. The sensorProbe8-X20 will alert you via e-mail, SMS (via email to SMS gateway) or via SNMP trap.
Alarming case of glass breakage / vibration via email, SMS, SNMP Trap
Should the glass break sensor with integrated vibration detector by burglary / vandalism are triggered, this is from the sensorProbe2, sensorProbe8 and securityProbe alarm servers immediately by
E-mail, SMS or SNMP trap to network management systems (Nagios, OpenNMS, WhatsUp Gold, etc.) reported.
The glass break detector with vibration detection can also with other smart sensors interact:
For example, the alarm siren are triggered with the flash or via sensor-controlled light relay are switched on.
AKCP vibrationDetect Sensor
The AKCP Vibration Detect Sensor is a normally closed input switch that will detect when there is vibration, or a window is broken. It can be connected to both the AKCP sensorProbe or securityProbe monitoring systems and then linked to notification alerts.
from 75,00 Euro*
Monitoring System 100 III - buy now
The advanced monitoring system 100 III is the entry level model of the high-end surveillance systems from Didactum. This monitoring appliance is designed and manucactured within the EU. The engineering and support of the Didactum monitoring systems are located in Germany.
from 239,00 Euro*
Specifications
- Circuit: Normally-closed contact, momentary open when activated.
- Contact Pressure: Adjustable from 1 to 50 grams but recommended setting between 5 and 25 grams only. Supplied with pressure of approximately 6 grams.
- Rated: 1A at 50VDC
- Contact Break Time: Approximately 45ms maximum (at 6-grams of pressure)
- Life: Over 100,000 contacts
- Contacts: Pure silver
- Weight: 20 grms.
- Size: 15mm(H) x 21mm(W) x 60mm(L)
- Case: ABS resin.