An important feature of the sensorProbe2DC is the ability to attach up to 5 dry contact inputs per RJ45 sensor port. Here you need the 5 INPUT DRY CONTACT CABLE.

By using two 5 Input Dry Contact cables with sensorProbe2DC, this gives you a total maximum possible inputs of 10 dry contacts.

These 5 Input Dry-Contact cables can be used to monitor any dry-contact inputs, just like the normal autosense dry-contact cables, but please note that these ports can only be set to operate in the input mode. In sensorProbe2 web interface these additional sensors are labeled as ports 3 to 12.

When you bought a sensorProbe2DC, this 10 dry contact feature is already enabled. If you just have an sensorProbe2 you need to buy the addtional software called DCUPGSP2.

First click on the "Sensors" tab, then please click on "Dry Contacts (3-12)" on the left.

Then press the button of the dry contact sensor that you want to use and place it online.
The additional sensors located on RJ45 sensor port 1 are the sensors 3-7, for second RJ45 sensor port they are named as sensors 8-12.


If you have any question about IP-based monitoring of dry contacts with sensorProbe2 DC, please contact our technical staff.