If the IPSet fails, is there any other method of assigning the IP Address?

Find out the IP address of your network adapter by entering the command "ipconfig" at the command prompt. In Windows 2000 and XP the command prompt can be accessed by clicking on Start -> Run -> and then typing in 'cmd' into the dialog box.

Add the IP address of the sensorProbe to the routing table by entering route add 192.168.0.100 x.x.x.x where x.x.x.x is the IP address of the network adapter

Add ARP table by entering arp -s 192.168.0.100 xx-xx-xx-xx-xx-xx where xx-xx-xx-xx-xx-xx is the MAC address of your sensorProbe

Ping 192.168.0.100 with a buffer size as 89 bytes. ping -l 89 192.168.0.100 If the browser and access the ping works then open up your web interface of the device by typing the IP 192.168.0.100.

back to AKCP FAQs